Page Contains Affiliate Links | Full Transparency Statement
mini-mod-gotsmok

4500mAh Mod (Takes AA Batteries) $9.95

Here’s a pretty cool 4500mAh Mini Mod that was brought to my attention via email. First off… it will power any 510 threaded atomizers using just 3 AA batteries. Second off… it includes 3 1500mAh alkaline batteries (non-rechargeable) to get you started. Third off… it’s available in three different colorways: black, blue & white. And lastly, this 4500mAh mini mod only costs $9.95 with FREE SHIPPING included. Not a bad mod to store in your glovebox to have in an emergency right? Anybody out there have any reason to think otherwise?

shop-now-gotsmok

Page Contains Affiliate Links | Full Transparency Statement

DEAL ALERTS

SIGN UP TO GET VAPE DEALS DELIVERED TO YOUR INBOX EACH AND EVERY DAY!!!

7 comments

  1. I have one of these, I got mine for 8.88 a while ago (same thing) and the downside is that its at a regulated 3.5 Volt output, so its only good/cool on itty bitty tanks, your CE5s, Protank Minis and what have you, but it is a little slick carbon fiber-esque plastic body, and it works I think from 1-3 Ohm coils… so its a very particular item, though for someone new, who wants a 0 Effs given mod, perfect lol

  2. oh the post says its a fixed 4.5 Volt output, but it looks exactly the same as the one I bought 6 months ago and its 3.5, just checked it on my Eleaf Meter… just FYI

    • Each AA battery is rated for 1.5V, but with sag it’s probably giving you a hair under 1.2V each.

  3. It could be dangerous a dangerous amp drain for each AA battery, especially since this would run them in series. AA batteries weren’t meant for the 10-20 amp pull that vaping usually requires.

  4. Running three 14500 batteries in series is WAY to much voltage, but with a little modification you can use one 14500 with room for two spares inside.

  5. do they have a name

  6. 3.6v nimh feels like a dead or few hours used lith at 3.6.

    Got to use 4 AA, nimh only, for big vape results. Use lowest resistance cart you can find VERTICAL coil, because 4.8v gives you a burned taste on the glass wick of horizontal coil cartomizers.

    Build a 2 or 3 wrap micro 24g coil, use cotton as a wick. Use 2.4v two AA nimh in parallel. Don’t use springs use copper wires and a high amp switch simple switch on negative NO MOSFET. 2 wrap gives you 24watts at 9-10 amps. Depending on the quaility of NIMH you get. HR6 “stay charge” LSD low self discharge are the current BEST. Any brand that is LSD they will say so in some manor. Excellent vape experience that last 6-8 hours on a FLAT energy drain curve.

    No safety risk except shorts. So build a GOOD mod that will not short or wear out and short. Use a good connector with good rubber orings. Replace adapters over time with worn orings. Then you’ll never short. I vape AA and have been doing so for almost 3 years. No ill effect. Vape until no smoke. Charge. Vape until no smoke. Charge. Repeat.

    Hard to under volt/over drain AA’s. I’ve dragged a straight wire, 20g from post to post. Attempting to dead short. But nope. It just glows hot and works. No ill effect. So build whatever you want.

ARE YOU OF LEGAL AGE TO PURCHASE

E-CIGARETTE PRODUCTS IN YOUR STATE?

The products talked about on this website are intended for ADULTS ONLY! By entering this website, you certify that you are at least 21 years old.